HOW TO PROGRAM YOUR RECEIVER(S) W/ THIS TRANSMITTER (OT-200)

Programming Guide * OT-200 

Step 4 * Program the Training Correction Levels (80 series) This program is seldom used. 

1. While in normal operation mode press and hold the Training Button on the transmitter until the display begins to flash *98*. 

2. Hold the receiver close to the edge of the transmitter board*.find the *Sweet Spot*. The receiver*s battery light comes on to indicate the receiver is ready to be programmed. 

 

NOTE: Should the receiver signal a solid tone and the light stays on this means that the receiver did not detect the transmitter*s signal correctly. When the beep stops repeat Step 2. 

3. Increase Training Correction Level - To increase the Training Correction Level, press the top black button. The receiver will beep twice to indicate an increase in the correction level and the low battery light flashes to indicate the training level the receiver is set on. You can only increase the correction level by 1 increment at a time. To increase the level more than one increment you must go back to the beginning of Step 4 and start over. 

 

If you try to increase the correction level once you have reached 89 the receiver will rapidly beep for approximately 2 seconds to indicate that the correction level is at its highest level (89). 

NOTE: Correction Level 88 is equivalent to correction level 31 and Correction Level 89 is equivalent to correction level 33. 

Decrease Training Correction Level - To decrease the Training Correction Level, press the bottom black button. The receiver will beep once to indicate a decrease in the correction level and the low battery light flashes to indicate the training level the receiver is set on. You can only decrease the correction level by 1 increment at a time. To decrease the level more than one increment you must go back to the beginning of Step 4 and start over. 

If you try to decease the correction level when the level is set to 81 the receiver will rapidly beep for approximately 2 seconds to indicate that the Correction Level is at its lowest setting (81). 

NOTE: If the receiver sounds a solid tone and the light stays on this means that the code is not compatible with the receiver and will not be successfully transmitted to the receiver. 

4. After reprogramming is complete the transmitter returns to normal operation. You can also return to normal operation by unplugging the power cord, waiting 5 seconds, and then reinserting the power cord. Alternatively, do nothing for two minutes and the transmitter will return to normal operation.